Callier-Scollard Violins
Craig Scollard

50 E. Green St. Suite 142
Pasadena, CA 91105
(626) 795-2870

Mon, Tue, Wed 10:00-1:00.
Thu, Fri, Sat 2:00 to 5:00

Intercom Access Code, Press:
142 and then the CALL button:

Search
Search Only:

Search Keyword: lots

Total: 12 results found.

Page 1 of 1



... lots of these and they are fairly easy to get apart and then rehair. There is a small hole at the back of the slide where you can put the bow screw into and push it out. When I rehair one of these bows, ...
... I want to glue it from the outside. Here are the steps. Unglue one seam Attach the clamping plate over the top. That way I have someting to clamp to. Glue the seam with hot hyde glue and lots of ...
3. Cello Top Seam
( General » Repairs )
... a cello. The odd thing about this cello was that the varnish wasn't really adheared to the wood very good. There were lots of spots that had the varnish chipped off. Also when I would put a clamp on, the ...
... came up with a new solution. Make a staple to hold the break. I get lots of bows that are not really worth fixing and usually the customer just leaves them with me. Normally if the broken bow has a full ...
5. Center Seams
( General » Repairs )
... would come apart. After steaming the globed on glue, it started to loosen up, then I could carefully peel it off. There were lots of small cleats and more glue on the inside. I thought the 1/2 glued cleats ...
... make sure the block does not move. If necessary, you can make a final adjustment to the amount of hair by cutting a few hairs out next to the block Replace the slide into the slots on the frog. ...
Here are some unusual bow plugs.     Here are some photos of a P & H Bows (London), it's the one with a plastic frog. I have seen lots of ...
... that had lots of rosin that was stuck in the varnish of the top. Instruments that have rosin embedded into the varnish need to be cleaned a little at a time. It sometimes takes several weeks of careful ...
... realized that the plastic part of the peg was slipping aghenst the metal part of the peg. There are fine slots on the metal and plastic that when engagued don't slip. In this case the plastic slots were ...
... was cracked in half and the bridge was broken.     Another sound post crack with lots of other cracks on the top. This instrument had lots of cracks a couple of ...
Thumb grips tend to wear down. Once you have worn down the leather you should have the grip replaced. I have seen lots of nice bows that have a large indent in the stick which could have easily been prevented ...
12. Bass Rib Repair
( General » Information )
This was a Bass with laminated ribs. The student's Father shut his rear deck-lid on top of the rib and it created a rather large hole with lots of shards of plywood.  Since this was only a student ...
Ask Us     Site Map     Top     QR Code