Callier-Scollard Violins
Craig Scollard

50 E. Green St. Suite 142
Pasadena, CA 91105
(626) 795-2870

Mon, Tue, Wed 10:00-1:00.
Thu, Fri, Sat 2:00 to 5:00

Intercom Access Code, Press:
142 and then the CALL button:

Search
Search Only:

Search Keyword: loose

Total: 13 results found.

Page 1 of 1



While in the process of rehairing a bow, you slide the ring off and the edge of the frog is broken and loose or it just falls off. Ugh. If it's an inexpensive bow and it lines up perfectly you can just ...
2. Loose bow wrapping
( General » Repairs )
When rehairing bows, sometimes the wrapping and the grip is loose. For those I do a quick fix and repair the existing wrapping. With this example the end of the wrapping was secure. Slide the grip ...
... of what seems like a soldered ball. That makes it easier to attach another wire to the soldered ball. Note: Before I loosened the volume pot, I tightly tied and glued a string to the shaft. Then I could ...
... when the hair is loose. You try to tighten it with 1/2 a turn but now the frog is too tight when you adjust the hair. This could be a couple of problems. The hole in the stick is worn out and needs ...
... a sharp knife cut away a space for the hair and wedge. Let it cure for 1 day. Test how well it's adhered to the frog. If it's loose glue the cast piece to the frog and wait till the next day. Finish ...
If the nut is loose and you need to reglue it. Clean off all of the old glue Make sure it fits. If not you need to fit the angles to match the fingerboard and the neck. Use a very small amount ...
... wood if the screw starts slipping out of the nut. Eventually the nut will completely give way or the threads will be too deep in the hole. If that happens you might loose the button or you won't be able ...
8. Center Seams
( General » Repairs )
... would come apart. After steaming the globed on glue, it started to loosen up, then I could carefully peel it off. There were lots of small cleats and more glue on the inside. I thought the 1/2 glued cleats ...
... securly. Here are the steps that I use to remove endpins. Loosen the strings Remove the bridge Remove the strings from the tailpiece Remove the tailpiece Remove the end pin plug. Since they ...
...  Glue the thumb grip if it's loose Tighten up the wrapping More Info. Remove the tip block Usually the block can be wiggled out, but care needs to be taken because the tip mortice is delicate. ...
When a rib is loose off the end block it can sometimes be repaired without taking the top off. This saves time and money. I recently repaired a rib without removing the top. First I completely removed ...
... because the bow will start to sometimes touch the "C" bout. Also the violin will loose some of it's projection. There are a couple of ways to solve this problem.   Dutchman The easiest and ...
... block is then replaced and the hair is slightly wetted, but you need to be careful not to get the hair wet near the wedge, otherwise it will wick under the wedge and the wedge will loosen up. Then the ...
Ask Us     Site Map     Top     QR Code