Callier-Scollard Violins
Craig Scollard

50 E. Green St. Suite 142
Pasadena, CA 91105
(626) 795-2870

Mon, Tue, Wed 10:00-1:00.
Thu, Fri, Sat 2:00 to 5:00

Intercom Access Code, Press:
142 and then the CALL button:

Search
Search Only:

Search Keyword: fitted

Total: 15 results found.

Page 1 of 1



1. Cello and Bass Bridge Fitting Guide
( General » Repairs )
... cut off a band saw can be used. Then the feet need to be fitted. I believe the best fit is achieved using a sharp knife. Fitting feet is a reductive process where you remove the section of the bridge ...
... hold the crack together. Then next time someone takes the top off they can simply remove and replace these magnetic cleats with some properly fitted ones.   ...
... glued and clamped. Next I cleaned out the center seam. Dry fitted the clamps and procedure so I could make sure everything lined up okay. Using hyde glue I clamped the seam back together using cello ...
When rehairing a bow and the frog is not seated correctly on the stick, it neds to be adjusted. Use a pair of needle nose plyers, don't use the bow's screw because you can easily wreck the lining. Usually ...
5. Center Seams
( General » Repairs )
... seam. Made a mold of just the center seam Created a couple of plastic molds Used the plastic mold to help me align the two halves while I chalk fitted the seams, both the left & right sides. ...
6. Peg Fitting
( General » Information )
Violin, Viola and Cello pegs eventually wear out or break. At that point you need a new set fitted. The first step is selecting the pegs you like. Then the peg holes are cleaned up a little so that ...
... this problem, the "A" peg was moved down 2mm and the "D" peg was moved up 2mm. First the boxwood bushings were fitted, then the outside faces were carefully made flush with the peg box. Then the new holes ...
FF Hole Cracks are very common for violin family instruments. Most of the time they can be glued from the outside. If the instrument is taken apart a well fitted cleat can be added to help strengthen that ...
... the fingerboard and at the body where the neck ends. A new bridge is fitted to match the new height.   This violin had low projection but I didn't want to increase the string pressure on the bridge, ...
... cellos do not have their necks fitted properly in the first place and they are not worth removing the neck and fitting pieces of maple or spruce, so I just flushed out the old glue, added new glue, aligned ...
... sterling silver is hand wrapped and then soldered all the way around at both ends. The solder is finished to the same thickness as the silver wire and then the thumb grip is fitted. Violin Sterling ...
12. Bass Rib Repair
( General » Information )
... carefully fitted together. (2) An interior patch is then fitted into the hole so that it covers the perimeter of the hole. This patch is made from maple that's about the same thickness as the rib. It's ...
... cleats. Once the cleats are inlaid and finished to the same thickness as the top, a new bass bar can be fitted on top of the stable crack.     If the crack is at least ...
... Bridge. *   Bass Bridge Fitting Standard: $195 plus the cost of the Aubert bridge. * Deluxe: $275 plus the cost of the Aubert bridge.   Bridges are hand fitted using a knife and ...
... Once the correct knot length is tied the frog block is put in. Then the wedge is fitted. At this point the hair is combed and slightly wetted. The length of the damp hair is measured and the hair is tied ...
Ask Us     Site Map     Top     QR Code